If part of the root gap is too wide the key hole will open up too much while welding and instead of penetration you may have burn through (more than 1/8 reinforcement) on the inside. The root gap around the pipe must be consistent. It is extremely important to set up and tack weld the pipe properly, if the pipe is not aligned on the inside it is difficult to obtain the proper penetration through the pipe. The pipe is assembled for welding by placing one piece on top of the other with a 1/8 electrode without flux on it between the pipe. The pictures below show the pipe beveling machine and the edge preparation. The slag is removed and the edges are ground smooth for welding a 1/8 landing or flat is applied to the pipe. The pipe coupons for welding are cut using the pipe beveling machine. The pipe welding positions covered are the 1G flat and rolled position, the 2G horizontal position, the 5G vertical position and the 6G fixed position as shown below. Welding pipe to pipe requires a higher degree of skill and is the topic of this supplement. When welding pipe to pipe the joint is similar to a vee groove and is often open root. When welding pipe flanges and some joints configurations the weld applied may be a fillet weld. Welding pipe is like welding any other structural shape and welding can take place in any of the normal positions for welding.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |